A Comparison: Optical vs. Capacitive (semiconductor) Fingerprint Sensors

www.virditech.com

[AC6000] How to equip AC6000 V2.0 HID iClass SE Module

[UNIS] ADMIN LOG ON PASSWORD

When you log on as master, please click as above and the initial password is "1"

support@virditech.com

www.virditech.com

[AC1000] How to use the AC1000 with Fire Alarm switch

[UNIS] ERROR CODE

UNIS ERROR CODE

• -  Normal processing 0000 : UNIS works fine.
  
• -  Communication Error 1010 : No response
  
• -  Error about Database 2003 : DB Access Error 2004 : DB Insert Error
  
• -  User/identification Error 3004 : Unregistered user 3005 : Matching fail
  3006 : No authority for access 3007 : Verify fake
  
• -  Error about terminal log on
  3001 : ID for a terminal is not registered
  3002 : ID for a terminal has already registered
  
• -  Errors from terminal
  5001 : Adding user is failed.
  5002 : Memory for terminal is full as data is downloading
  5005 : another data is required although flash has already written.
  5006 : Users who need to server is not found
  5007 : Upgrading firmware is not possible because version is not suitable. 
  
  
  
  
  
  support@virditech.com
  
  
  www.virditech.com

[UNIS] SERVICE

UNIS install environment

UNIS is installed regardless of window system type (32-bit operating system or 64-bit operating system).

How to stop and restart UNIS service

When changing UNIS setting or DB setting, you have to restart UNIS service. - Control Panel > Administrative Tool > Services

1. Stop UNIS services

Stop this order : UWork Service - UNIS_Server - UDBServerService

2. Restart UNIS services

Start this order : UDBServerService - UNIS_Server - UWork Service 

support@virditech.com

www.virditech.com

[UNIS] The meaning of signals on Terminal Status

The meaning of signals on Terminal Status

support@virditech.com

www.virditech.com

[VIRDI TERMINAL] VERIFY MULTI - FP

There is VERIFY MULTI - FP in Menu of VIRDI terminals.

It is a function that it could be authenticated if it inputs all registered fingerprints after register One ID with two people's fingerprint.

If checked ( ), this function has all the registered fingerprints to be authenticated after

the user inputs ID (or Card). When this item is set to checked, the user must, without

fail, input user ID or card. In this case, Enable 1:N is automatically changed to

unchecked ( ).

This function is used for strict access control to special zones. For example, if the

user with ID ‘0001’ is registered with 3 fingerprints they must input ID and complete the authentication for three fingerprints.

In this case, the order of authentication for the 3 fingerprints is irrelevant, but the

fingerprints should be repeatedly input until authentication is successful. Authentication will fail on a single occurrence of authentication failure.

support@virditech.com

www.virditech.com

[AC6000] How to Set Up Voice Volume

The older hardware version than v2.0 can’t be improved to be louder the voice volume of the AC6000 when it was communicated with the door phone even if the firmware was upgraded because it comes from the initial hardware design.

On the other hand, if you used the AC6000 (v2.0), you can get loud the voice volume by means of the attached guidance.

However, if you’re unsatisfied even though you set the voice volume to maximum, there is no solution because it needs to be changed the hardware design.

support@virditech.com

www.virditech.com

[AC5000] How to use the AC5000 with Fire Alarm switch

[AC2100] How to use the AC2100 with Fire Alarm Switch